PP PE Film Recycling Line

Main technical parameter:

1. Adopt the hydraulic packing shearing machine, which will pack the films, and cutting as the size of 150-200mm. each pack cuts 5-7 knife.

2. Then going to belt conveyor, the belt conveyor has melt detector.

3. After belt conveyor, it has roller screen, make the films loose, the waste sand, stone can take out when on roller screen. After entering the sanding machine, through high-speed rotation, a mesh hole is provided in the barrel to discharge some small debris, silt and small metal,

4. and then enter the crusher. At this time, the material contains about 10% of sediment.

Reduced wear on crushers and Blades.

5. The material after crusher, it goes to high speed friction washer, then going to floating washer machine.

6. The film material stretch in the water, with four rollers to stay more time in the water, than the dirty material will be down on the tank , then go into low speed friction machine.

7. further cleaning, into the next level rinse tank cleaning and separation,

8. spiral feeding plastic into the extruder, the extrusion material is in a semi-plastic state, the water is about 7-8%, through the air sent to the storage room for natural evaporation water

9. After the granulation, it was fed with a side feeding and two-stage filtration, and the water ring was pelletized.

The complete pp pe film recycling line consists of :

1. Conveyor belt,

2. Crusher with water

3. Friction cleaning machine,

4. Sedimentation rinse tank,

5. Spiral elevator,

6. Dewatering machine,

7. Duct drying system,

8. Silo,

9. control panel and other components.

Our service:

STPLAS Machinery Co.,Ltd is a leading manufacturer of plastic recycling machine since 2008. We can offer OEM service to meet your special requirements.

Stephen

Phone/Wechat/Whatsapp:+86 13962506463