- Home
- >
- News
- >
- Company News
- >
- rolling separator for plastic recycling machine
rolling separator for plastic recycling machine
1. Application
ST Series rolling separator is well designed and well improved, which is
widely used as plastic auxiliary machineries. There are ten kinds, which are
mainly used to separate soft and rigid material, bottle, film and rubbish and so
on.
2. Characteristic
ST rolling separator is made of carbon steel, surface adopts Zinc plated,
which will not pollute material, and adopt nylon wheel, which is with low noise
and wearable. This series separator can be designed with different length and
diameter according to different material to adjust inclination angle. There is
magnet equipped on the board to suct the magnetic material. The speed can be
changed according to different material with immovable speed and frequency
control.
3. Operation
1) Please check anchor bolt whether has been fixed before starting to avoid
Vibration of machine.
2) Please let the machine run for 3-5 minutes without material and check the
turning of major axis, if the turning is right, then you can put the material.
3) This series machine can be used alone, also connected with whole production
line.
4. Attention
1) Industry lubricant must be added into reducer regularly (one month), and
lubricant L-AN100 will be added every week, oil level see as picture
2) Every shift should clean the dust and rubbish to keep the machine in good
condition.
3) The chain will stretch after using a long time, and then it will skid to hit with
the cover, so you must adjust it see as the picture. When the machine is
closed, adjust the bolt under the motor; first loosen the chain to proper
extent.
4) Please pay attention to the top wheel whether it is against the top of toggle
Plate, it is necessary to adjust the bolt to make the top wheel to push toggle
plate, see as the picture.
5) Keep the machine connects with the earth to avoid electric leakage.
6) Main technical data
Model | Power(kw) | Diameter(mm) | Length(mm) |
ST-1800 | 5.5 | 1800 | 7000 |
7) Malfunctions and trouble-shooting
No. | Malfunctions | Reason analysis | Trouble-shooting |
1 |
It doed not start | 1) Power supply is not connected well or fuse is broken. 2) Button and contactor is not connected well. 3) Motor overload | 1.Check power supply and connect fuse firmly 2.Fasten connection or adjust contactor |
2 | Bearing is broken
| Replace bearing with same model | |
3 | Vibration of machine | Anchor bolt is not flat | Adjust anchor bolt |
4 | Chain collides with cover | Chain is loose | Fasten chain and bolt |